[Elecraft] Question about installing KAT1 in my K1

[Anthony Hardwick]

Okay, so here's confirmation that I am, in fact, an idiot.  After re- 
reading the manual for the KAT1 several times, I FINALLY noticed the  
warning that "the following steps are only necessary if you have  
revision D or earlier of the K1 RF board."

Well, to help out idiots like me, I still suggest that a revision to  
the manual is warranted.  I bet I'm not the only one who will miss  
that little note.  Since I can't imagine there are any RF boards still  
going out at this point from Elecraft that are Rev. D or earlier, why  
not update the manual for the KAT1 at least?


On Jul 7, 2009, at 8:19 PM, Anthony Hardwick wrote:


> If I'm wrong and I overlooked proper instructions then I apologize,
> but I have been through the documentation several times, and can't
> find any evidence of up to date instructions for the revision RF board
> I have.
>