[Elecraft] INTERFACING A KENWOOD SM220 BANDSCOPE WITH A K3

JPHN POWELL powell.john at xtra.co.nz
Wed Jul 1 18:55:01 EDT 2009

Previous message: [Elecraft] K1 minor stumbling block...
Next message: [Elecraft] INTERFACING A KENWOOD SM220 BANDSCOPE WITH A K3
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

I am intending to interface my K3 with a Kenwood SM220 and installed the Elecraft KXV3 Interface to achieve this. Is there any other problems that may occur, other than to retune the SM220 bandscope input to the K3 IF frequency ?.
Comment and suggestions, ideas, etc. will be most welcome
Thanks in advance.

John Powell. ZL1BHQ

Previous message: [Elecraft] K1 minor stumbling block...
Next message: [Elecraft] INTERFACING A KENWOOD SM220 BANDSCOPE WITH A K3
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

More information about the Elecraft mailing list