[Elecraft] K3 Sub Rx idea

[Milt, N5IA]

GM Wayne,

I understand A/B and the swap per AB2TC's comment.  But there are some of 
the settings which do not follow.  I know you know and will address them if 
at all possible.  It was just my dos centavos thrown into the pile.

73, and thanks de Milt, N5IA

----- Original Message ----- 
From: "wayne burdick" <n6kr at elecraft.com>
To: "Milt, N5IA" <n5ia at zia-connection.com>
Cc: <mike at paxsen.com>; "Elecraft Reflector" <elecraft at mailman.qth.net>
Sent: Saturday, January 31, 2009 9:55 AM
Subject: Re: [Elecraft] K3 Sub Rx idea


> I'm gradually weeding out commands that don't work in BSET mode. Until
> then, you might want to do A/B, change the setup, then A/B again.
>
> 73,
> Wayne
> N6KR
>
>
> On Jan 31, 2009, at 6:40 AM, Milt, N5IA wrote:
>
>> Wayne,
>>
>> The most undesireable aspect of BSET is the fact that the
>> communication with the computer is interrupted.  The logging program
>> dispays a pop-up window indicating lost communication if BSET is in
>> use for more than a few seconds. At least that is my experience while
>> using N1MM.
>>
>> Milt, N5IA
>>
>> ----- Original Message ----- From: "wayne burdick" <n6kr at elecraft.com>
>>
>>> The BSET switch *is* intended as a context swap that allows the front
>>> panel to control the sub receiver. It already allows control of many
>>
>>> 73,
>>> Wayne
>>> N6KR
>>
>>
>>
>
> ---
>
> http://www.elecraft.com
>


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.10.16/1926 - Release Date: 1/30/2009 
5:31 PM