[Elecraft] PowerSDR-IF

[Don Wilhelm]

Sam,

I am not using a Softrock with the K2, but the principle is the same as 
that indicated in the article you referenced.  The K2 IF center is close 
to 4913 kHz, but will vary from K2 to K2, and the CW center frequency 
will be different than the SSB filter center.

Your softrock receiver will have its own center frequency.  So do 
exactly as the article says - subtract them and enter that into PowerSDR 
as your initial trial.  That will get something on the screen at 
approximately the frequency indicated by PowerSDR.  That can be refined 
by using a signal of known frequency.

73,
Don W3FPR

Sam Morgan wrote:
> Here is my question:
> If anyone is using this PowerSDR-IF software
> with a Softrock as an IF for a K2..............
>
> What IF Frequency(s) have you entered on that "Softrock IF Stage" tab.
> for LSB, USB and CW ?
>
> About 3 pages down from:
> http://www.wu2x.com/sdr.html#gettingstarted
>
> you will find an image of the "Softrock IF Stage" tab:
> http://www.wu2x.com/images/setup2.jpg
>
> http://www.wu2x.com/sdr.html
>   
>