[Elecraft] Need Help with XG1

[Ron D'Eau Claire]

Of course, change the interconnecting cable or adapter between the XG1 and
your rig. Coincidental failures are rare, but not impossible. 

Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Pete Smith
Sent: Wednesday, January 28, 2009 9:54 AM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] Need Help with XG1

Thanks for the idea - I removed both D1 and D2 from the circuit - no 
improvement.  The signal is quite audible (in the 50 uv switch position, 
and barely audible in the 1 uV position, but doesn't move an S-meter that 
was formerly tested with it and registered S9.

Anyone else?  I know that if I had a scope I could measure the p-p voltage 
coming out of the oscillator, but I don't.

73, Pete N4ZR

At 11:49 AM 1/28/2009, Philip Carter wrote:
>See if maybe you shorted the protection led.
>
>
>
>--- On Wed, 1/28/09, Pete Smith <n4zr at contesting.com> wrote:
>
> > From: Pete Smith <n4zr at contesting.com>
> > Subject: [Elecraft] Need Help with XG1
> > To: elecraft at mailman.qth.net
> > Date: Wednesday, January 28, 2009, 11:19 AM
> > I have an XG-1 Receiver Test Oscillator which I must have
> > accidentally
> > zapped with RF somehow (I don't know when) because the
> > output resistors
> > R6-8 were fried.  I replaced them, as well as R4 and R5, C4
> > and the
> > transistor.  The slide switch in the output tests ok.
> >
> > When I turn the XG-1 on, I can very faintly hear its
> > signal, so it appears
> > that the oscillator is working, but the output level is
> > nowhere near what
> > it should be. Voltage at the top of C3 is 1.23 volts.
> > Anyone have any
> > ideas where else I could look?  Elecraft tech support was
> > helpful but
> > ultimately gave up.
> >
> > 73, Pete N4ZR
> > the World Contest Station Database is back, and updated
> > daily
> > www.conteststations.com
> >
> >
> > _______________________________________________
> > Elecraft mailing list
> > Post to: Elecraft at mailman.qth.net
> > You must be a subscriber to post to the list.
> > Subscriber Info (Addr. Change, sub, unsub etc.):
> >  http://mailman.qth.net/mailman/listinfo/elecraft
> >
> > Help: http://mailman.qth.net/subscribers.htm
> > Elecraft web page: http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com