[Elecraft] [K3] KRX3 Installation R91 mod

[Dave Van Wallaghen]

Thank you all for the great suggestions. The rest of the installation 
went well except for one hitch that Bill had mentioned about the tabs on 
the KRX3 PCB. In my case, I tried to get it to fit but found that all of 
the tabs running from the front to back (right and left sides looking 
from the front of the K3) were offset by almost 1/8" to the rear. All of 
the other tabs (front and rear) matched just fine in the shield. I filed 
the side tabs down and everything fit FB.

The setup went without a hitch and I'm sitting hear playing with it and 
wishing I had a vertical outside right now to play around with some 
diversity reception ;-)

Thanks again for the suggestions and hopefully this thread will help 
someone else down the road.

73,
Dave W8FGU