[Elecraft] Proper cable for signal link to go with K3

[N8XPQ]

What are you planning on using the Signalink for? I don't know that it would
do anything more than the already existing one that is included in the K3.
If you do want to use the Signalink however, you will need the 8 pin Kenwood
cable and then just setup the header inside the Signalink accordingly.

Best of luck,
Mike N8XPQ


Alex and La Nell wrote:
> 
> 	What cable should I order to attach usb signal link to K 3. ? 
> 
> 	Thanks
> 	Alex
> 	
> KR6G  
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 

-- 
View this message in context: http://n2.nabble.com/Re%3A-Proper-cable-for-signal-link-to-go-with-K3-tp2201735p2203514.html
Sent from the Elecraft mailing list archive at Nabble.com.