[Elecraft] Question on AGC Threshold voltage during Test and Alignment Part I

[Fred Keller]

I just completed the Test and Alignment Part I.  All tests passed with
flying colors.  However, when I set the AGC Threshold Voltage using R1, the
maximum voltage I was able to reach was 3.67V with the pot at the end of its
range.  I checked this value with both my DMM and the onboard volt meter and
they agreed within 0.07 volts.  Is this an issue since I was unable to
achieve 3.8 Volts?  If so, where should I look for the problem?

Thanks in advance,

Fred, KC9QQ
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20090120/8b2f9019/attachment.html