[Elecraft] More on K3/XV-144 without rigblaster

[Don Wilhelm]

Eric.

See the manual page 19.  If one must use the TX INH function, the K3 ON 
signal is not available to the XV transverter.  The K3's 12 volt output 
can be used instead of the K3 ON signal.

73,
Don W3FPR

eric norris wrote:
> I'm not sure where this thread has gone but let me bring it back to where it started.  
>
> Several people have suggested using TX INHIBIT from the sequencer to the K3, but the XV-144 uses pin 7 of the ACC plug (where TX INH is) for the K3 ON signal.  If I configure TX INH, will the XV-144 still work correctly?
>
> All help apprectiated.
>
> Thanks,
>
> Eric WD6DBM
>   
>