[Elecraft] K3: How to determine TX Frequency Over Serial Port

[Julian, G4ILO]

Simon (HB9DRV) wrote:
> 
> Look at the IF command - saves a few steps.
> 
> 
The IF command only gives the RX frequency. It will tell you if you are
working split or have XIT on as well, so I suppose it saves a few commands,
but as it sends a lot of other info you don't need it's arguable what you
are saving. You could send FT;FA;FB; as one string and then sort the results
out afterwards.

-----
Julian, G4ILO. K2 #392  K3 #222.
http://www.g4ilo.com/ G4ILO's Shack   http://www.ham-directory.com/ Ham
Directory    http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3 
-- 
View this message in context: http://n2.nabble.com/K3%3A-How-to-determine-TX-Frequency-Over-Serial-Port-tp2114913p2117017.html
Sent from the Elecraft mailing list archive at Nabble.com.