[Elecraft] K3 KPA3 bias adjust

[Jan Erik Holm]

Thanks Ron but I knew this already.

Probably have to write to K3support and ask,
however I´m very surprised nobody could answer
on the reflector.

Jim SM2EKM
----------------------
Ron D'Eau Claire wrote:
> Hello Jim:
> 
> That pot, along with all the other trimmers in the K3, is adjusted at the
> factory. There are specific cautions against touching any of them in the
> field; all field adjustments are done in firmware.  
> 
> If you have a problem with the KPA3, suggest you post a message to
> K3support at elecraft.com. If an adjustment is needed that can be done in the
> field, one of the fellows there can give you specifics. 
> 
> Ron AC7AC
> 
> 
> 
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jan Erik Holm
> Sent: Saturday, January 03, 2009 6:55 AM
> To: Elecraft at mailman.qth.net
> Subject: [Elecraft] K3 KPA3 bias adjust
> 
> I find nothing about it in any manual. R11 on KPA3
> I guess. What are the specifications for the bias
> adjust?
> 
> 73 Jim SM2EKM
> 
>