AW: [Elecraft] Isolation between Ant 1 and 2??

[Koppendorfer Klaus]

yes isolation between ant1 and ant2 is very bad...
if I have time I try to change the silgle wires from the rs323 ports to the atu-board to koax wires, maybe this will help a little

73
OE6KYG
KX1 244
K2 1331
K3 115
> -----Ursprüngliche Nachricht-----
> Von: elecraft-bounces at mailman.qth.net [mailto:elecraft-
> bounces at mailman.qth.net] Im Auftrag von Dick Roth, KA1OZ
> Gesendet: Samstag, 03. Jänner 2009 06:14
> An: Elecraft Reflector
> Betreff: [Elecraft] Isolation between Ant 1 and 2??
>
> Hello and Happy New Year!!
>
> Was doing some testing and discovered Ant 1 signal on Ant 2.  Ant 1 is
> my GAP Titan-DX and Ant 2 is a 100W dummy load.
>
> I was just reading the mail on 75 meters and switched to Ant 2 to test
> power.  When key was off, I heard part of the QSO that was going on.
> While on my dummy load, I was receiving a station S3, which on Ant 1 was
> 20 over S9.
>
> Has anyone else seen this crosstalk?  If so, what is considered
> "acceptable"?
>
> --
> 73,
> Dick ka1oz
> Middleborough, MA
>
> Radio:  Elecraft K3/100(Kit) SN 859
> Antenna:  Titan-DX
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com