[Elecraft] Logic 8 & K3

[Gary Smith]

I am using the Kenwood 850 @ 4800 baud, 1 stop bit and Icom address 
1E

When I click on a spot in the spot log, it takes me to the frequency 
posted on the cluster and it also logs the contact. If I do not make 
the contact I need to erase the qso. Double clicking on a new 
station/frequ8ency it logs the new one in sequence rather than 
writing over it. It does require each attempt to be erased or it will 
mean entering qsos in the log that never happened. (often there is 
nothing to hear and yet Logic has this listed as a completed QSO.

Another thing is if I click on a DX spot, the K3 is switched to the 
REV condition if it is a CW contact. Every time I use the double 
click on spot log, I always need to press the ALT key to restore the 
CW to normal.

With the above, does anyone know how to allow me to double click on 
spot log without it going to rev in CW and... How to not have to 
always erase the contact when going from the spot log to the 
frequency?  

Thanks,
Gary
KA1J