[Elecraft] KX1 appears dead after KXB3080 PCB installed... ...Help please!

[ShawnMorrow]

I want to close out this thread now that my KX1 is back on the air on 80, 40,
30, and 20 meters.

I was doing another close visual before following up on Don's advice to
remove Q9.  During that process I must of dislodged something that was
causing a short in the vicinity of T2.  There were a couple of through holes
I had difficulty clearing to mount T2 and I think perhaps there was solder
ball or something that was hidden by T2.  Once dislodged everything came
"back to life".  Needless to say I was quite relieved!!

So, this re-enforces Don's advice to check the soldering closely and perhaps
to pay attention to any solder debris that might be left "laying around."

Don - thanks for the tips and assistance to help me through this.

73, W4SDM

Shawn Morrow
Fairfax, VA

-----

   Shawn Morrow
      W4SDM
-- 
View this message in context: http://n2.nabble.com/KX1-appears-dead-after-KXB3080-PCB-installed...-...Help-please%21-tp2266733p2344222.html
Sent from the Elecraft mailing list archive at Nabble.com.