[Elecraft] CW-to-DATA

[Ron NA9F]

Two questions:

1st.  While using the internal CW-to Data mode I notice a 4 sec idle
transmit period before exiting to receive mode. Is there other way besides,
sending "..--" at the end of your tx, to switch to receive?  I think 4
seconds of idle state is way too much and do not really like to have to send
..-- after each transmission.  

2nd.  What has anyone found out about tuning in a PSK signal that may not be
covered in the manual?
It seems like some stations can be easily tuned fin while others are much
harder.  I have noticed that Digipan copies better then the K3's decode but
it may be my inability to get the tune right.

Ron NA9F
-- 
View this message in context: http://n2.nabble.com/CW-to-DATA-tp2341909p2341909.html
Sent from the Elecraft mailing list archive at Nabble.com.