[Elecraft] Feature request

[Val]

> "Quick split" - otherwise known as "auto split" or "pileup split" - is
> an option that has been available in serious transceivers for almost
> twenty years.
>
> If this option was available and selected, then holding SPLIT would
> automate the following sequence which presently has to be done manually:
>
> 1. Double-tap A>B (reset VFO B, and sub-rx if present, to a known state)
>
> 2. Hold SPLIT.
>
> 3. Tune VFO B away from VFO A by a selected amount (+/- in 1kHz steps,
> either by pre-selection or 'on the fly' - but the latter would require
> extensive error trapping).
>
> 4. Turn sub-rx on (if it wasn't already on).
>
> 5. Disable TX on VFO A frequency until SPLIT is canceled (error trapping
> for the A/B, REV and A>B buttons).

6. Switch VFO B display to show VFO B frequency if it currently shows some 
voltage, temperature, decoded text, etc.


73 Val, LZ1VB