[Elecraft] K3-KRX3 Clarification

[Terry Schieler]

I am completing the installation of my KRX3.  I am electing to share the
selected antenna (ANT-1 or ANT-2) with the sub receiver.  I have the KAT3
installed.  Do I still need to connect the 12” TMP cable between the KRX3
and J92 on the KAT3, or is this connection made somewhere else in the
circuitry?

 

On page 37 of my KRX3 installation manual (Rev. A) it states “If installed,
attach the antenna cable connected to either the KAT3 or to the AUX RF BNC
jack on the rear panel to J92 at the end of the KRX3 as shown”.  I DO have
the KAT3 installed, but am confused if this cable is REQUIRED for the sub
receiver to work at all, or if this step is referencing the option to
“Installing the Auxiliary KRX3 Antenna Input Via the KAT3” which I have
elected to pass on. 

 

I don’t see any other way of the signal getting from the ANT connection on
the back of the rig to the sub receiver, but, then again, there are a number
of multi-pin connections on the sub receiver.

 

Please respond direct as I am in digest mode and would like to wrap this up
this afternoon if possible.  My call AT swbell DOT net.

 

Many thanks.

73,

Terry, WØFM

K3/100 #474

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20090215/0faeb829/attachment.html