[Elecraft] K3/100 Assembly - Initial test & Cals

[Doug Joyce]

Walter- I'd go ahead and use the firmware that the unit was shipped with to do all the calibration following the build.  You can always do an update after and it is very easy using the instructions on the web site and the K3 utility.

I built mine in early Jan and have done 4 upgrades without a hitch.  

73 

Doug,  VE3MV
K3/100 S/N 2432
  ----- Original Message ----- 
  From: Walter V. Gilles 
  To: elecraft at mailman.qth.net 
  Sent: Sunday, February 15, 2009 12:32 AM
  Subject: [Elecraft] K3/100 Assembly - Initial test & Cals


        Greetings,

        I am just starting the initial test and cals portion of assembly, prior KNB3 enable and KPA3 installation.  Power-up went fine with no errors.  Before I start with Synthesizer Cal and move on, is now a good time to update the firmware to latest release, then do all the cals?  I'm guessing so, but confirmation appreciated.  Thanks much.

        Walter, N0DZJ 




------------------------------------------------------------------------------


  ______________________________________________________________
  Elecraft mailing list
  Home: http://mailman.qth.net/mailman/listinfo/elecraft
  Help: http://mailman.qth.net/mmfaq.htm
  Post: mailto:Elecraft at mailman.qth.net

  This list hosted by: http://www.qsl.net
  Please help support this email list: http://www.qsl.net/donate.html

-- 
I am using the free version of SPAMfighter.
We are a community of 5.9 million users fighting spam.
SPAMfighter has removed 1012 of my spam emails to date.
Get the free SPAMfighter here: http://www.spamfighter.com/len

The Professional version does not have this message
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20090215/b8cb3918/attachment.html