[Elecraft] K3 Transmitter gain

[Julian, G4ILO]

John Lemay wrote:
> 
> Hello all
> 
> It's several months since I assembled my K3. There have been half a dozen
> software revisions in that time, all of which I have loaded. Some of the
> revisions have been aimed at improving power control.
> 
> Should I run through the TX gain calibration process again to get the most
> benefit from the revised software ?
> 
> 
I run the TX gain calibration process as a matter of principle after
installing any firmware update. It can't do any harm and it may - due to
internal changes within the firmware - make a difference. If you use the
wizard in the latest Elecraft Utility it takes next to no time.

-----
Julian, G4ILO. K2 #392  K3 #222.
http://www.g4ilo.com/ G4ILO's Shack   http://www.g4ilo.com/blog.html G4ILO's
Blog    http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3 
-- 
View this message in context: http://n2.nabble.com/K3-Transmitter-gain-tp2329144p2329228.html
Sent from the Elecraft mailing list archive at Nabble.com.