[Elecraft] K3 Beta firmware rev. 2.82

[Steven.Zabarnick at notes.udayton.edu]

I discovered that my cw power issue was due to a bad power supply for my
Elecraft W1 wattmeter. My cw power measurement now agrees with the K3
setting. I still see a 50% higher power output in Data A mode than the K3
setting -- this is an improvement over the nearly 100% that I was seeing
using previous firmware. These observations agree with what G4ILO is
seeing.


>
>I installed the new beta last and tested the new output power control. >I
don't see any improvement in PSK31 output power using DATA A mode. I >still
get nearly twice the output power than I have dialed in by the >PWR knob.
In the previous firmware, the measure output power in CW >modes agreed with
the PWR knob setting, but now the power output in CW >is 20-30% higher than
the setting.
>
>
>I will try to redo the transmitter gain calibration to see if this >helps.
>
>Steve N9SZ
>
>K3 #1672