[Elecraft] Negative ALC Mod

[Brett Howard]

So I wasn't going to do this one cause I pretty much didn't plan on
using it this way but since new K3's are being built this way I've
decided that its one that I need to get done to my rig.

I'm wondering if using SMT resistors rather than through hole parts is
possible?  I'm sure its fine for the 2.2K pull ups but for the 1%
parts I'm not so certain.

Also I have the 100K's in 1% and I have the 137K's in 1% but the 69.8
I don't have... I have access to a 5% 68.1K....  Looks like I have 1%
68.1K's in the stock room too but I'd have to go find those...

Any ideas on this?