[Elecraft] K3 and PSK31

[Don Wilhelm]

Jim,

Use DATA MD = DATA A.

If you have the K3 set for VOX operation, that should be all that is 
required.
If you choose to use PTT, set the K3 for PTT and select either RTS or 
DTR in the CONFIG: PTT-KEY menu *and* select the same signal for PTT in 
the Digipan application.

I don't normally use Digipan, but I just tried it and it worked FB for me.

73,
Don W3FPR

Jim Miller wrote:
> OK, Stupid question, I can't believe I can't get this running.
>  
> PSK31 operation PC to K3, Digipan (then HRD/DM780 when I get it 
> figured out, one thing at a time).
>  
> Windows XP pro, Digipan, both signals checked on the comm 1 port for 
> transmit, NO Rigblaster, serial cable direct to 1.7 gig PC, sound 
> "card" on the mother board, K3/100 (plus options).
>  
> What mode am I supposed to have the K3 in?
>  
> 1. Data, Data A, vox or not = won't go into transmit.
>  
> 2. USB mode, goes into transmit and transmits data as expected except 
> that the frequency is 600 Hz above the VFO setting and does not follow 
> the waterfall frequency.
>  
> Works fine on 746 through original Rigblaster, I didn't think it was 
> supposed to be needed on the K3.
>  
> TIA, 73, de Jim KG0KP
>  
>  
> ------------------------------------------------------------------------
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.0.234 / Virus Database: 270.10.21/1945 - Release Date: 02/11/09 08:01:00
>
>