[Elecraft] (no subject)

[Don Wilhelm]

Mike,

The 0 - 9 buttons are 'quick memories' and are the same as normal 
memories 0 thru 9.
If you have data stored in the normal memories 0-9, then tapping M>V 
followed by a tap of the appropriate button should retrieve the memory 
contents.

If you want the 0-9 buttons to act like 'band select' buttons, then set 
the CONFIG: MEM 0-9 menu to BAND SEL and once settings are stored for 
any frequency in a band, those memories will return to the last used 
frequency, mode, antenna selection, filter selection on that band.

You can also use the 0-9 buttons to store those memories.  Set up VFO A 
and VFO B each with their modes and other settings.  Then tap V>M 
followed by a tap to one of the 0-9 buttons.  To retrieve, tap M>V 
folowed by a tap to one of the keypad 0-9 buttons.


The M1-M4 buttons are similar, but are PER BAND.  That means you must 
select the band first.  Then you may store or retrieve the memory 
contents for each of the 4 buttons.  Tap V>M, then tap the M1-M4 button 
to store.  Tap M>V followed by one of the M1-M4 button to retrieve.

W0MU Mike Fatchett wrote:
> Ok I read the manual and I have been unable to program the m1-m4 keys or the
> 0-9 keys.  I can program a normal memory just fine.  
>
> Is there a menu setting that I am missing or did I have to do something in
> the K3 utility program to get this to work?
>
> Mike W0MU
>   
>