[Elecraft] Calibration of KXV3 module

[Don Wilhelm]

James,

The HT antenna is frequency sensitive, so it will not work. A dummy load 
will work fine.

73,
Don W3FPR

James Sarte wrote:
>
> Dear group,
>
> Page 50 of the user manual states that a 50 ohm resistor should be 
> attached to the XVTR OUT jack for calibration. If I don’t have a 
> resistor, can I use a 50 ohm BNC stubby HT antenna instead since 
> output is only 1 mW?
>
> 73,
>
> James KC2UEE
>
>