[Elecraft] K3 Beta firmware rev. 2.82

[Joe Planisky]

I don't see a problem with CW on my K3 (29.4W measured, 30W  
requested,) but there are definitely still problems with excessive  
power output in DATA-A.  DATA-A initially output the correct power,  
but after switching to AFSK-A and back to DATA-A, I get well over 2x  
the requested power out (71W measured vs 30W requested.)

73
--
Joe KB8AP


On Feb 11, 2009, at 6:16 AM, Steven.Zabarnick at notes.udayton.edu wrote:

>
> I installed the new beta last and tested the new output power  
> control. I
> don't see any improvement in PSK31 output power using DATA A mode. I  
> still
> get nearly twice the output power than I have dialed in by the PWR  
> knob. In
> the previous firmware, the measure output power in CW modes agreed  
> with the
> PWR knob setting, but now the power output in CW is 20-30% higher  
> than the
> setting.
>
> I will try to redo the transmitter gain calibration to see if this  
> helps.
>
> Steve N9SZ
> K3 #1672
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html