[Elecraft] k3 multiple XV tranverters cabling

[Don Wilhelm]

Eric,

The connector on the XV transverter series is DE-9 not DB-15.  The 
DB-15s will fit the K3 ACC connector.
Yes, the connectors are normally a daisy-chained Y cable for all except 
the end devices. but I suppose they could be all single cables going to 
a "spider" hub created from Y cables, although it should be tested - 
that arrangement may be more  prone to noise pickup.

73,
Don W3FPR

eric norris wrote:
> Is there any reason why I can't use a simple Y-cable to extend the cabling from one XV transverter to two?  I bought a handful of  DB-15 Y-cables from Cable Wholesale (based on a recommendation from this list) and so far they have worked FB   I use one DB-15 to split off PR6 control, another for the XV-144, and one for a top-ten band decoder.  Any reason why I can't add another when I finish my XV-432 and stack it on top of my XV-144?
>
> 73,
>
> Eric WD6DBM  
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 9.0.722 / Virus Database: 270.14.123/2592 - Release Date: 12/29/09 02:47:00
>
>