[Elecraft] K3 Sub Rx antenna input choices
srife at swbell.net
srife at swbell.net
Tue Dec 29 21:52:06 EST 2009
I'm thinking of a relay at that point to switch between them. But
then I guess there goes your isolation afforded by the BNC.
Would a Y cable affect the input Z enough to affect the gain?
Stan Rife
W5EWA
-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Ken Kopp
Sent: Tuesday, December 29, 2009 3:05 PM
Cc: elecraft at mailman.qth.net
Subject: [Elecraft] K3 Sub Rx antenna input choices
I purchased my sub-receiver for one specific use ... to monitor
6M for band openings while the radio might tuned to another
band. I used the Elecraft-supplied BNC(F) to TMP(M) cable
to feed the sub-receiver's input. This arrangement is essentially
"permanent" unless one does a partial dis-assembly to gain
access the sub-receiver's input jack.
I later decided that I'd like more flexibility regarding the choice
of antenna for the sub-receiver. I now route the cable from the
BNC(F) to the area atop the sub-receiver and secure it to the
knurled nut on the top of the sub-receiver. I also routed the
cable from the antenna tuner to the same area and secured
it along with the end of the cable from the rear panel BNC(F).
Next I made up a short (6") TMP(M) to TMP(F) cable that
plugs -permanently- into the sub-receiver's input. This short
cable is also routed to the same area as the ends of the other
two cables. Now, by lifting the top cover of the rig, I can choose
which source is fed to the sub-receiver's input via the short
extension cable.
It's -much- easier to gain access to the sub-receiver's antenna
jack if the KI03 is removed. It's easy to damage the input jack
on the sub-receiver if you try to plug a cable into the jack from
above.
73! Ken Kopp - K0PP
ElecraftCovers at rfwave.net
http://tinyurl.com/7lm3m5
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
More information about the Elecraft
mailing list