[Elecraft] Sub Receive

[Iain MacDonnell - N6ML]

On Sun, Dec 27, 2009 at 11:26 PM, Richard Thorpe <kissov at earthlink.net> wrote:
> I have my sub receiver connected to a "receive only" antenna through the BNC connector on the K3 rear, the coax from the BNC goes to the second receiver board.  I assume this is the only way a signal can get to the sub receiver? a signal cannot be routed via the ATU to the sub receive board?

Not true, but it requires hardware reconfiguration. See the KRX3
manual, page 24:

http://www.elecraft.com/manual/KRX3_Subreceiver_Install_and_Operate_Rev%20D.pdf

Also see the section on antenna routing in the K3 manual.

    ~Iain / N6ML