[Elecraft] K3 Main RF Gain problem

[Jim Byers]

To All

Your input was helpful and appreciated,  Thanks.

Problem solved.
It was the Rf Gain Calibration that caused the problem.

Initial  run was done using a MacPro running Snow Leporad problem may 
have started here. ( will check into that tomorrow)

Second and Third runs done on a MacPro using Boot Camp and Win 7 64bit 
Home Premium
Went Straight to the option of using the  XG 2 as the source. (a mistake 
on my part should have known to start from a known state) Problem still 
there after both runs.

Fourth run done on a MacPro using Boot Camp and Win 7 64bit Home Premium
Picked first option of writing factory values only.
Problem Gone.

Fifth run done on a MacPro using Boot Camp and Win 7 64bit Home Premium
Used XG 2 as source Problem Gone

Short version_ Stay with Factory defaults_ unless you have a good reason 
to make a change.

Jim
VE3AJ

On 09-12-23 11:33, Wayne Burdick wrote:
> Lyle and I will look into this issue when he gets back from vacation.
>
> 73,
> Wayne
> N6KR
>