[Elecraft] Q

[Terry Schieler]

Just how did this post get in here?  Isn't this the "Noisy K3 Receiver"
forum.  ;o)

Terry, WØFM

(sorry David)

-----Original Message-----
From: David [mailto:David_Close1 at bigpond.com] 
Sent: Saturday, December 19, 2009 5:12 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Q

Hi,I am building the K2 and the control board is done and checks out
fine.The Front Panel is done but in the check list of J1 pins 1-20 pins 1-7
show 0 ohms pin 8 shows .12 ohms pin 9   0 ohms this is not consistent with
checklist all else checks out ok , solder looks good no solder bridges could
please make a suggestion David