[Elecraft] K2 front panel board

[Don Wilhelm]

Conway,

Although I have not seen it before, it is possible that a bit of the 
solder mask material has gotten into that solder hole.  Try sticking a 
toothpick or similar tool through the hole.  If that does not clear it, 
consult with support at elecraft.com.

73,
Don W3FPR

Conway Yee wrote:
> I am working on the front panel board.  I have a problem with pin 10 of
> RP1.  The hole is not completely formed.  There is a small sliver of green
> plastic blocking the hole about half way through the board.
>
> Suggestions?
>
> tnx.
> Conway Yee, N2JWQ
>   
>