[Elecraft] K3: Noisy Receiver? - not here!

[Bill W4ZV]

Bill W4ZV wrote:
> 
> You will not need to modify a new K3.  The mod was implemented around S/N
> 3010 last April/May.  New unit S/Ns must be approaching 4000 by now.
> 

For the record, here's the information from Elecraft:


"We started shipping the latest DSP boards, Rev C, approximately May 1st,
2009.  Any K3 DSP board Rev C or later will have the extended low end audio
response enhancement.

This corresponds approximately to K3 serial number 3018, plus or minus
10-20. 

Since assembled -Fs and kit K3s flow through different manufacturing paths,
there is a slight variance in s/n for the phase-in. 

If in doubt, check the DSP board Rev as noted above.

A picture of the Rev label location :

http://www.elecraft.com/K3/mods/dsp_rev_c_information.htm

(The 'C', or later, revision letter at the bottom of the label is what is
important.)"


To order the mod kit, order K3DSPUPGD here:

http://www.elecraft.com/order_form_parts.htm#K3%20Parts


73,  Bill

-- 
View this message in context: http://n2.nabble.com/K3-Noisy-Receiver-not-here-tp4181034p4181412.html
Sent from the Elecraft mailing list archive at Nabble.com.