[Elecraft] K3 - PowerSDR-IF "communication issue?"

[Lee J. Imber (WW2DX)]

Hi Bill,

Try over here:

http://code.google.com/p/powersdr-if-stage/

73!

Lee
WW2DX

On Dec 15, 2009, at 12:54 PM, Bill Davis Jr wrote:

> 
>  Hope someone can help. Downloaded PSDR-IF 1.19.02 last night to use with my K3 and my Softrock on the IF with a Clifton Labs buffer. No problem with using the panadapter centered on the IF. But when I selected the K3 IF setting in PSDR and hooked up the serial cable I expected to be able to do some K3 control via PSDR and that does not happen. The serial cable works fine with the K3 Utility. I'm guessing I have made a dumb error some where. Correct Com port (1) and only serial cable hooked to computer when I was trying it.
> 
>  Ideas? .... From PSDR-IF documentation it sounded like once the IF/K3 option was selected it should have been close to "plug and play". My serial cable is 2 conductor and ground. Again works fine with K3 Utility and I have Upgraded FirmWare etc with no issues.
> 
>  Thanks .. Bill  K0AWU  EN37ed  K3# 3460
> 		 	   		  
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html