[Elecraft] WM-2 operation

[T Gahagan]

Thanks for explaining this since my W2 is acting the same way.  I will use 
the W2 utility to change to AVG power.

Todd, WA7U

--------------------------------------------------
From: "David Fleming" <dflem at yahoo.com>
Sent: Sunday, December 13, 2009 2:58 PM
To: <elecraft at mailman.qth.net>; "worsr" <worsr at comcast.net>
Subject: Re: [Elecraft] WM-2 operation

> It sounds like your W2 is set to display PEP power. Use the 'Command 
> Tester' in the W2 Utility to send the "M" command to the W2. This will 
> toggle between PEP and AVG power. There will be software available soon to 
> easily set all of the W2's parameters.
>
> David, W4SMT
>
> --- On Sun, 12/13/09, worsr <worsr at comcast.net> wrote:
>
>> I am having trouble understanding the
>> operation of my WM-2.  When I select the range
>> manually, all is well and the meter functions as it
>> should.  However, if "Auto" is selected, the meter
>> seems to show a  high peak reading upon initial keying,
>> i.e. with rig set to approx 100W output, the meter will show
>> a peak of about 150-160 W.  SWR as measured by the
>> meter is < 1.5:1.  ALso, when "auto" is selected,
>> the 20W LED also lights up.  None of my other meters
>> behave like this, and indeed, the WM-2 doesn't either when
>> in "non-auto" mode.
>>
>> Thanks for any help.
>>
>> --Mike, W0RSR
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>