[Elecraft] [KX1] KX1 ATU problem

[Don Wilhelm]

Is it possible that you upgraded the firmware when you added the 
KXB3080?  If so, the menu entries are set to default, and that means it 
is set to ATU CAL - check the menu.

73,
Don W3FPR

KD0FIN wrote:
> So I just installed the KXB3080 and completed the 2 resistor "power mod" but
> now my ATU doesn't seem to be working. It gives me power and SWR reading
> when I use the "tune" function but I don't hear the relays clicking and it
> isn't matching anything anymore. It might be unrelated but also it seems to
> be very hard to find signals as well. I could hear a couple faint ones on
> 80m but everything else seemed dead. The radio was working as normally as I
> could tell after installing the KXB3080, and I don't think I could have
> screwed up the the 2 resistors enough to cause any problems?
>   
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 9.0.709 / Virus Database: 270.14.103/2558 - Release Date: 12/11/09 05:06:00
>
>