[Elecraft] Band Switch questions

[Wes Stewart]

Ahem, I'm going to top post my reply ;-)

I use the M1-M4 memories as you do, Wayne.  That said there would be merit to having a 75/80 meter separation at least in the band output info that drives decoders like the KRC2 that are used for automatic antenna selection.  



--- On Thu, 12/10/09, Wayne Burdick <n6kr at elecraft.com> wrote:

> From: Wayne Burdick <n6kr at elecraft.com>
> Subject: Re: [Elecraft] Band Switch questions
> To: "Randy Tomer" <w6ra at yahoo.com>
> Cc: elecraft at mailman.qth.net
> Date: Thursday, December 10, 2009, 2:15 PM
> 
> On Dec 10, 2009, at 1:08 PM, Randy Tomer wrote:
> 
> > 1) Is there a way to eliminate the 60 meter band in
> the band switch  
> > sequence?
> 
> Yes; see CONFIG:BND MAP.
> 
> >
> > 2)  Is there a way to separate the 80 meter band
> into 75 m / 80 m  
> > two different bands?
> 
> No, but you could use two different memories set to your
> favorite  
> starting points, then use M>V to get there quickly.
> 
> What I do is set up the per-band quick memories for
> different modes  
> and starting points on each band. In the case of 80 m,
> tapping M>V /  
> M1 gets me to CW mode at 3540, M2 is LSB at 3900, M3 is
> AM-SYNC at  
> 3870, and M4 is PSK31 at 3580.
> 
> 73,
> Wayne
> N6KR
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>