[Elecraft] LP-Bridge Question

[Richard Ferch]

Lee,

The current version (0.9.976) of LP-Bridge seems to work well with N1MM 
Logger. Previous versions did not work so well with the Logger, but this 
one seems to do the job. My basic normal setup is similar to yours (COM1 
connected to the radio and a WKSUB for CW). With LP-Bridge I can run 
N1MM Logger, SDR-IF Stage with the LP-PAN, and other software such as 
MixW and DXLabs simultaneously without any obvious problems.

N1MM Logger's support of the second receiver (interactions between SUB, 
SPLIT, and DVRSTY) is not perfect; ditto for its support of CW keying on 
the computer control serial port - but so far, when I have encountered 
problems with either of these I have found that the problems persist 
even when LP-Bridge is taken out of the picture, although some 
timing-dependent problems may display different symptoms.

73,
Rich VE3KI

Lee K0WA wrote:
> OK, I am behind the times here and have been reading the thread about LP-Bridge.  I \
> am going to play with this when I get home this evening....but...I have a question.
> 
> How does it interact with N1MM Logger?  Are there issues? 
>