[Elecraft] LPA power tran's standoff's

[Julian, G4ILO]

VE3WDM wrote:
> 
> 
> Greetings,
> When it was time to put the bottom cover on over the LPA unit I found the
> cover did not fit all that well. Seems one of the power transistors was
> sitting a bit high. With some playing I was able to get the bottom cover
> on but still wondering if anyone else had this trouble? I checked the
> standoff's and washers all was good but it still was sitting a bit high. I
> did look at the LPA unit and it was fully seated and level as per the
> instructions. Any ideas....
> Mike
> 
> 

I presume you are referring to the K3 low power amplifier? Yes, I did find
the same thing. I eased it back up a bit so it was not quite fully seated
but it was still about a millimetre higher than it needed to be.

-----
Julian, G4ILO. K2 #392  K3 #222.
* G4ILO's Shack - http://www.g4ilo.com
* KComm - http://www.g4ilo.com/kcomm.html
* KTune - http://www.g4ilo.com/ktune.html

-- 
View this message in context: http://n2.nabble.com/LPA-power-tran-s-standoff-s-tp4138898p4139948.html
Sent from the Elecraft mailing list archive at Nabble.com.