[Elecraft] K3 Noise blanker board

[Bob Cunnings]

Well, according to the K3 schematic, pin 5 of the connector shows 'no
connection'. This would be the 8th pin from one end.

Bob NW8L

On Wed, Dec 9, 2009 at 4:14 AM, Mike Weir <ve3wdm at hotmail.com> wrote:
>
> Good morning all
> Almost finished putting the K3 all together but last night I did notice while putting the NB board on the 8th pin from the left was missing. I ended up plugging it into the main board but will wait to find out if this is intentional or defective before I power up the unit.
> Thanks
> Mike
> VE3WDM