[Elecraft] Config:Wattmeter

[Robert Dorchuck]

I have built two K3's (the last one in March 09) and the calibration worked 
fine
then.

As you say, there are work arounds but it would sure be nice if the K3 
worked
as the manual shows.

Bob  W6VY




This bug in the wattmeter calibration still exists in the latest firmware.
Pressing XMIT during the wattmeter calibration does not transmit, and
pressing TUNE does not permit a change of the calibration paramter. On the
other hand keying the rig via a keyer does allow the calibration to be
performed.

Steve N9SZ