[Elecraft] K3 mods

[Steven Zabarnick]

Yesterday I overcame my fears :-) and successfully performed the  
following mods on my K3 (S/N 1672):

K3 AF Mod (Line out & speaker)
IF Output Buffer Gain Mod
K3 Extreme Signal RX Protection Mod

But, I was not able to perform the K3 AF Output Mod (two 470 ohm  
resistors on the KIO3 board). I found it impossible to hold the  
resistor in place will soldering to the connector pins. Does anyone  
have any suggestions on techniques for installing these resistors?

Steve N9SZ