[Elecraft] K3 NR triggering

[.k8dd.]

Joe Planisky wrote:
>> Some times you can't satisfy all the people all the time with one  
>> road.
> 
> Truer words were never spoken!
> 
> I'm a full time CW operator (well, 99.9% CW, 0.1% digital modes.)  I  
> played with the pre-3.25 NR quite a bit and I was never able to find a  
> setting that made a CW signal easier to copy, so I never actually used  
> it in a QSO.  Post-3.25, I find I'm now using it more often than not.  
> My preference would be for progress to continue in the 3.25/3.27  
> direction.  Of course, ideally they'll come up with a way to let each  
> operator use what works best for them.
> 
> 73
> --
> Joe KB8AP


I also operate mostly CW .... 3.27 isn't bad, but over the year or so I 
think the best DSP firmware was DSP 1.81   It was one of the better 
balances of audio level for NR on/off.  And the CW signals came up out 
of the noise - or the noise went down.  But ..... it doesn't work right 
anymore with the newer MCU & FPF levels.  That DSP is part of 
k3fw2r10.zip which I have labeled  "FD 08" in the folder with all the 
old firmware sets.
73    Hank    K8DD

____________________________________________________________
FREE 3D EARTH SCREENSAVER - Watch the Earth right on your desktop!
Check it out at http://www.inbox.com/earth