[Elecraft] K3 connector

[Alan Bloom]

The P3 has a similar connector, but it is internal to the cabinet.  It
is for programming the boot loader and initial firmware at the factory.

Alan N1AL


On Thu, 2009-08-20 at 17:45 +0100, David Ferrington, M0XDF wrote:
> Elecraft's use in testing and service - not usable by 'end user'  
> although in the early days there were mutterings on it's use for  
> attachments. I'd consider it not to be there until/if something  
> eventually comes along - the P3 will not be using this as far as I know.
> 73 de M0XDF, K3 #174