[Elecraft] P3 display of K3 filter bandwidth and other information

[Matt Zilmer]

I like the limb you're out on.

Will there be a cursor function, similar to a spectrum analyzer - or
does the P3 auto-center frequency in the IF center?  If the answer is
yes, text display of peak/average dB of a selected signal could be
done.

Maybe the cursor already exists and I just didn't see it on the face
of the engineering unit at SB.

73,
matt

On Mon, 17 Aug 2009 11:58:05 -0700, you wrote:

>The P3 is connected to the K3 at a point ahead of the crystal filters,  
>so when you change crystal filters on the K3, it won't change the P3's  
>displayed waveform.
>
>However, the P3 will be aware of the K3's filter bandwidth and offset,  
>so we can show a bracketed or otherwise highlighted area on the P3  
>display that reflects the filter settings. We could show both the DSP  
>and crystal bandwidth using different colors.
>
>Going farther out on a limb: The P3 could highlight ham-band edges and  
>band segments, even by license class, programmable by country. It  
>could mix spectral and waterfall displays with decoded text. You could  
>assign a function switch as an auto-tune switch for PSK31 -- etc.,  
>etc. (Somebody stop me!)
>
>73,
>Wayne
>N6KR
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html