[Elecraft] Auto-Notch Broken in 3.25 (I probably missed this)

[Dick Roth, KA1OZ]

Ken Wagner K3IU wrote:
> Hi Dick:
> 
> Something is funny about this, 'cuz lots of folks have said it is not 
> working and lots, including me, say it works just fine. Only thing I can 
> think of trying to possibly correct it is to do a *complete *reload of 
> the firmware. I have had a couple of occasions where that fixed weird 
> problems in the past.
> 
> 73 from just down 24 a bit...
> 
> Ken K3IU
> K3 #202
> Portsmouth, RI
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~``
> Dick Roth, KA1OZ wrote:
>> Tried listening for the Elecraft SSB net at 1800.  There was a 
>> heterodyne or other interfering signal on 14.316.  I tried to use 
>> Auto-Notch, but nothing changed.  Then I went to manual and notched it 
>> out completely.
>>
>> Hope I'm not adding too much noise to the FW discussion!
>>
>>
>>   

Thanks for the suggestion, Ken.  I reloaded and still have the same 
condition.  Doesn't matter whether AGC if fast or slow.  The tone 
doesn't wander much and in manual mode I can quiet the tone and not have 
to fuss to keep it quiet.


-- 
73 from just up 24 a bit,
Dick ka1oz
Middleborough, MA

Radio:  Elecraft K3/100(Kit) SN 859
Antenna:  Titan-DX