[Elecraft] K3 10 Hz passband shift

[Bob Cunnings]

What mode are you in? The 10 Hz passband shift applies only to CW and
DATA modes, per the release notes.

Bob NW8L

On Fri, Aug 14, 2009 at 8:48 PM, Ron W3ZV<w3zv at verizon.net> wrote:
> Okay, I'm doing something dumb once again. I downloaded the latest and
> greatest firmware and the newest K3 Utility. Uploading to the K3 was
> uneventful. The Utility shows all the latest versions installed. I'm
> excited about the 10 Hz passband shift, so that's what I tried to
> implement first.
>
> I went to CONFIG:PB CTRL and attempted to change the shift to .01 using
> the  VFO A knob. All I got was  N/A. What highly obvious and intuitive
> step have I missed this time? I think this radio was designed expressly
> to keep me humble! :-)
>
> Thanks
>
> Ron W3ZV
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>