[Elecraft] [K3] I try again..message from admuin..post is pending..

[James Sarte]

It's simple to connect the K3 to the TL-922 via ARB.

Key relay output from K3 to input of ARB.  Output from ARB to Key relay
input of TL-922.
RF patch from K3 output to TL-922 RF input.

That's it.  You're good to go.  No need to run ALC; the SB-220's can take a
lot of abuse and is almost impossible to overdrive with the K3.  Just tune
with about 20w to 30w drive to begin, then peak at max smoke.  Adjust
exciter drive power to control final output power.

73 de James K2QI

On Tue, Aug 11, 2009 at 2:22 PM, Lars Midtboe <lmidtboe at yahoo.no> wrote:

>
> New on reflector and im exited waiting for my K3  :-) and studying
> manuals...(at work at my ship..home in 2 weeks and will pick up my new K3)
>
> Want to use my TL-922 with amp.buffer Arb-704 but hard to understand
> manuals.
> Any here who has done this amplifier connection??
>
> 73 de Lars M....La2rra
> --
> View this message in context:
> http://n2.nabble.com/I-try-again..message-from-admuin..post-is-pending..-tp3425819p3425819.html
> Sent from the [K3] mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>



-- 
73 de James K2QI