[Elecraft] PL1 Error on 10M

[Ron D'Eau Claire]

Granted, Bill, it's more complicated with the KRX3 installed. It might
involve an extra 10 minutes of work to remove/replace the KRX3 RF module. (I
do it in less than five, about 1 min to get it out and the rest putting it
back, but I've done it dozens of times.)

It's a gamble. One might save a few minutes taking the shortcut, unless a
simple mistake is made. Then it'll take a lot longer to put things right
again.

To each his own. The Elecraft procedures focus on the *safest* way for
everyone to proceed. The expert solder jockeys can get away with shortcuts -
usually :-)

Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Bill W4ZV
Sent: Saturday, August 01, 2009 4:22 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] PL1 Error on 10M




Ron D'Eau Claire wrote:
> 
> It seems a poor choice to try installing that resistor with the Syn board
> in
> place when it's "hammer simple" to pull the board and work on it properly.
> 

Not if you have a KRX3 installed!

73,  Bill