[Elecraft] Knobs

[James Sarte]

In my case, the original knobs were perfectly concentric in that the shaft
holes were centered properly.  Unfortunately however, those were the ones
that cracked.  Both sets of replacements that I received from Elecraft had
off-centered shaft holes.  This is the reason why I ended up purchasing the
machined knobs from Mouser.

James K2QI



On Fri, Jul 31, 2009 at 10:54 PM, drewko <drewko1 at verizon.net> wrote:

> I have K3 #1029. The nested knobs are perfectly concentric to my eye.
> The Shift/Width knobs don't fall off and are not too short. None have
> cracked in one year of almost daily service.
>
> Perhaps there have been some incompatible production variations along
> the way. I don't doubt you are having a problem but have to disagree
> with your comments about design. The original design seems perfectly
> adequate if #1029 is any indication.
>
> 73,
> Drew
> AF2Z
>
>
>



-- 
73 de James K2QI