[Elecraft] Anderson Power Pole Turtotial and Tool Suggestion

[Don Wilhelm]

Terry,

Properly assembled 30 Amp power pole connectors require 6 pounds of pull 
to disengage/engage.
If your are not staying mated, I would suggest that you look for a 
source of pulling on the wires and/or be certain your APPs are properly 
assembled.  If you used a crimping tool that distorts the tabs, that 
alone could be the reason for a loose connector.  I suggest you use a 
proper crimp tool, or solder the connections (without getting solder on 
the outside of the barrel).  If you are using soldered connections in a 
high vibration environment such as a vehicle, be certain to reinforce 
the wire for about 2 inches away from the connector (2 layers of heat 
shrink) to keep the wire from flexing - constant flexing will cause the 
wire to break right where the point that the solder has wicked to.

73,
Don W3FPR

Terry wrote:
> I have a problem with APPs staying mated (specifically in my vehicle).  
> I've always wondered why there isn't some sort of positive latch.
>
> 73 de Terry KK6T
>
> Elecraft K3/100 #????  (kit received yesterday)
>
>   
>